|
If you have spark and fuel the first thing youll need to do is verify that the ignition timing is correct.
Do the following:
- get a timing light
- In the ECU Manager Software:
1. Setup>Main Setup
- Click the tab that says "Fuel"
- Uncheck the box that says "Enable Injectors", this will turn OFF the injectors
2. Setup>Main Setup
- Click the tab that says "Ignition"
- Select the drop down item that says "Ignition Lock" > Enable this feature
- Set the Locked Timing Value to 0 Degrees
Now with the timing light have someone crank the motor over, and move the cam sensor until the timing light flashes at 0deg on the Crank pulley.
Once you have done this, go back and enable the injectors and try to start the vehicle.
There are a few other things that you'll need to check:
- TPS Voltage
- Coolant and Air Temp Sensor Readings
- Is the map set up to run VE or Injector PW Based Tuning?
There are TONS of reasons why the car may not fire right up, but this is a good place to start.
- john
|