Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - This is the roll center, suspension pickup, and steering angle modification thread.

Def · 05-06-2010, 06:49 PM

Some decent M14x1.5mm rod ends would be the MINIMUM you'd need to run those things, so definitely a "must buy." There's still a risk of snapping the shanks due to low articulation with a typical 3 piece rod end and no reliefs on the spacers to give more angle.

I wouldn't run a stainless steel rod end in this application - its strength is far less than an alloy steel.

05-06-2010, 06:49 PM	#747
Def Post Whore! Join Date: Apr 2004 Location: Houston, TX Posts: 2,701 Trader Rating: (16)	Some decent M14x1.5mm rod ends would be the MINIMUM you'd need to run those things, so definitely a "must buy." There's still a risk of snapping the shanks due to low articulation with a typical 3 piece rod end and no reliefs on the spacers to give more angle. I wouldn't run a stainless steel rod end in this application - its strength is far less than an alloy steel. __________________ S13 Hatch - Goes around tracks quickly DEFSPORT