s13 uneven front camber
 

So , i was just changing some settings before going to the alignment shop so the car will only need minimal adjustments.

I put the top knuckle bolts all the way in , and the camber plates were at the same position.

What i realized is that the driver's side (Left) has 1.5-2 more camber and wheel pokes out .

I later adjusted only the right side to hopefully bring it to the same camber but still big difference.

Car has :

Stock lca with new ball joints and pu bush
Daiyama coilovers
Driftworks tension rods
GK tech RCC

At the moment , in the attached photos with my camber tool i see:
Right : 4.5
Left: 5.5+ ( tool maxes at 5.5)

https://ibb.co/0hjcrvC

https://ibb.co/xfsjVJr

https://ibb.co/w7Rfgq5

Your camber plates aren't set up the same.

https://i.ibb.co/Npjv4My/Screen-Shot...0-08-17-AM.png

Notice that this camber plate has 5 bolts? that fifth bolt and hole are moving one of your shocks over a good quarter of an inch or so.

Yes i know that.

But if adjust it to get the same camber numbers, both plates will be setup completely different.

What i want to keep is the knuckle bolts all the way in so the dampers work on a more straight position and adjust the camber only from the plates which looks impossible.

Am i thinking correct?

What difference does it make if the camber plates are set up differently or the same?

Is it just missing that Allan bolt?

Sorry if it?s a dumb question, I don?t really mess with those settings on the camber plates


Sent from my iPhone using Tapatalk