**WSRD Brake Line Relocation Kits!**
 

http://i.imgur.com/M206GjE.jpg

Our brake line relocation kits route under the factory crossmember, cleaning up the bay and making room for turbo setups. They're compatible with S13/Z31/Z32/Pathfinder master cylinders and are made in the USA! Teflon braided stainless line coated in a protective teflon outer shell means these are built to last! (Pictured with V1 High pressure power steering line).

Comes with all the fittings to connect your master cylinder to the caliper and rear brake line(s).

http://www.whalentuned.com/nissan-240sx.html

Zilvia price: $199 shipped! PM me to order!

Do you offer the lines from the front and rear calipers also? Or can you recommend a good brand for those of similar quality.

We don't currently offer the caliper lines, but we recommend and install Goodridge lines here at the shop on a variety of vehicles. We can get them both to you in the same box.

Nice !!!
Is it made to order? if so, what is turn around time?
ChaseBays took 391 weeks... LOL

HAHA, they are made to order, but the maximum turn around time is four weeks. We usually get them done in two.

Damn I should have waiting till this special to order mine.

Price on these brake lines and also the clutch line (from master to slave) shipped to 91042 lmk

installed my kit finally, went in fantastic! more than enough line and everything went together smoothly. kit is easy to figure out. would support Whalen again!!!

You have a PM good sir.

I'll shoot you a quote later today.


Thanks for the kind words! Good to hear!

do you have before and after shots of engine bay?

Is the fitting with the o-ring seal that goes into the high pressure side of the rack an off the shelf item or is it custom made? I've read that the off the shelf fittings do not correctly seal because they are slightly short and what people have done is machine it to get the o-ring to fit correctly.

I only have after shots unfortunately!

http://i.imgur.com/r4ObvcA.png


We use off-the-shelf fittings, but we've never had an issue with them leaking. I feel like people are often afraid to tighten them all the way.

I know this says s13,z31,z32 but... I have a s14 master and I need this kit. Would it work or can you make me one?

This kit won't work with a S14 master. If you were local, we could make you a kit, but I don't feel comfortable building a kit without the ability to test fit it. I've been trying to get a S14 in here for a while now, but so far haven't been able to. When we do, we'll build a kit and post it up!