Rod Bearings Loose During Assembly.
 

Hey guys. I'm rebuilding my KA, had a bad rod bearing. I replaced the bearings and noticed that they seem loose! Plasti gauge was within spec I believe. Is this just because there is little lubrication? I did use a little assembly lube. I'm really hoping that they aren't suppose to be oversized bearings. I've tried searching with no prevail. Here's a video: View My Video

Sent from my 0PJA2 using Tapatalk

No that is not right at all. Did you have an machine work done on the crank? If so, you definitely need oversized bearings. Ive never seen any play like that unless it had a spun bearing

Nope, never had any machine work done, last owner must have! I have a friend with a stock crank, should o switch cranks instead of going switching rod bearings? Or should I measure and get correct bearings for my crank?

Sent from my 0PJA2 using Tapatalk

Bump? Would like to know wether or not I should get a stock crank, or buy oversized bearings.

Sent from my 0PJA2 using Tapatalk

Up to you... either way will solve the problem

Yes, and no.


Truthfully, I'd be measuring that rod end too, if it's egg shaped may as well use it for a door stop

If the other crank is in good condition I'd go that route

Awesome thanks for all the replies. Got the crank, will start doing a bunch of mesurments and I'll let you guys know how it goes!

Sent from my 0PJA2 using Tapatalk