PBM comp question
 

Got my PBM competitions today I mounted the rear fine when I went to throw the fronts on I mounted the tops fine and when I got to the lower hub bolts the pbm hole to fit the bolt through is too skinny to fit the OEM size bolts... Any suggestions? The car is s13 hatch

Is the mount on upside down?

Do you maybe have s14 lower control arms? Because you might also have s14 hubs, which would mean you have a larger bolt for that. I'd just get a 14mm IIRC drill bit and fix'r up. Or contact PBM and see about getting s14 lower mounts.


Definitely double check though.

grab a drill dude

Yeah 5 lug S14 swap! Just clicked! I need it ASAP to get my car on the ground and running! Need to contact PBM!

Anybody know if PBM will send me out just the s14 mount?

Just go get s13 bolts. I have the same setup and got a spacer so I could use the s13 bolt on s14 knuckles with no play. Otherwise, just drill out the hole.

i don't know for sure. but you should call the konig distribution center. they'll know for sure. speak to greg. tell him steve sent you there.

preciate it you know if they open saturday?

probably just get the spacer for the knuckle! and wait for PBM to send me the new one!

Should it affect the rear?

Attachment 39277

Got to work!