Many parts for sale
 

PM me for the fastest response.
I have more stuff I'll add later when I take pics.


Z32 TT speed sensor-$60

http://i92.photobucket.com/albums/l5...t/z32ttvss.jpg


OEM driver side S13 chuki side skirt-$50 picked up
Was pretty beat but I fixed the damage.
Still needs some work(mostly sanding),

http://i92.photobucket.com/albums/l5...deskirt001.jpg

http://i92.photobucket.com/albums/l5...deskirt002.jpg

http://i92.photobucket.com/albums/l5...deskirt003.jpg

http://i92.photobucket.com/albums/l5...deskirt005.jpg

http://i92.photobucket.com/albums/l5...deskirt004.jpg


Rear side markers-$10
Both are in good condition.
Sockets and harnesses are included.
Fronts are sold

http://i92.photobucket.com/albums/l5...markers001.jpg

S13 chuki bumper center bracket-$20

http://i92.photobucket.com/albums/l5...perbracket.jpg

S13 chuki bumper vents-$15

http://i92.photobucket.com/albums/l5...chukivents.jpg

White Bunny clutch setup-$80
Setup is used but in good condition.
Lots of life left on the disk.
It's an OEM Nissan Z32 clutch with a D21 flywheel.
Includes the throwout bearing and clutch bolts.
Will fit both SOHC and DOHC KA motors.
Part of the trans backing plate needs to be trimmed so the flywheel doesn't rub(see the last 2 pics).

http://i92.photobucket.com/albums/l5...bclutch001.jpg

http://i92.photobucket.com/albums/l5...bclutch002.jpg

http://i92.photobucket.com/albums/l5...bclutch003.jpg

http://i92.photobucket.com/albums/l5...bclutch004.jpg

Before
http://i92.photobucket.com/albums/l5...dustshield.jpg


After
http://i92.photobucket.com/albums/l5...ustshield2.jpg

Z32 1 piece drive shaft-$140
This is for a 5spd non-turbo 2 seater model.
Made by Drivelines Inc.
It's 40in from u-joint to u-joint and 48in overall.

http://i92.photobucket.com/albums/l5...t/100_6805.jpg

http://i92.photobucket.com/albums/l5...t/100_6804.jpg

Z32 ignitor-$25

http://i92.photobucket.com/albums/l5...2ttignitor.jpg

Lower subframe collars-$20
These go on the bottom of the subframe mounts.

http://i92.photobucket.com/albums/l5...t/100_6817.jpg

440cc top feed injectors-$50
These are low impedance from a mk3 Supra turbo.
Should work with CA18 and KA-E motors.

http://i92.photobucket.com/albums/l5...t/100_6772.jpg

Z31 turbo hood scoop-$20

http://i92.photobucket.com/albums/l5...t/Z31scoop.jpg

Z32 dash mat-$20

http://i92.photobucket.com/albums/l5...t/100_6798.jpg

FC RX7 oil cooler-$50
Couple dents but no leaks.
Has a built in thermostat.

http://i92.photobucket.com/albums/l5...lcooler001.jpg

http://i92.photobucket.com/albums/l5...lcooler003.jpg

http://i92.photobucket.com/albums/l5...lcooler002.jpg

K&N drop in filter-$20
Cleaned and re oiled with the K&N cleaning kit.

http://i92.photobucket.com/albums/l5...Nfilter004.jpg

Key ring light-$12
Has a green bulb.

http://i92.photobucket.com/albums/l5...t/keylight.jpg

Let me get the clutch line and the key light with the clutch set up hit me up to 213 399 9592 thanks

Back up to the top.

Free bump b/c u r too far from me.

Last time to the top.