Fuse Box Relocation
 

so im in the process of relocating my fuse panel from the engine bay to the trunk. i have a pretty good idea of how im going to do it and ill post a write up type deal when im done but im stuck ha.

i was going to depin and repin everything but its turning out to be a little more pita due to the fact all the plugs have different pin configurations. so i plan on cutting/ resplicing. so im here looking for recomendations on how you guys usually do it.

cut harness and resplice that is. if anyone has recomendations on depinning id be open to that as well

There's Tons of write ups on this...

I cut mine up blind folded and then hot glued everything back together. Car runs a bit sluggishly, but hey, I get from point A to B just fine w/ AAA.

Actually i finished it yesterday. Was way easier than expected and works fine. Engine bay looks 10x cleaner