Ka24de no crank
 

Just replaced my s13 de with another s13 de and i cant get it to crank i believe i have everything hooked up correctly. Is there something that i may have overlooked?

yes there is something you overlooked

:werd: msglnght

lol like what? all grounds are connected, fuel pump primes, all interior electronics working

Try telling us a little bit more about you problem, you are very bland

did you happen to mess with the harness as well, or just swap the motor?

is the battery charged? any of the plugs left unconnected? is the starter clicking at all? blow a fuse or relay?

starters not clicking at all, but it was ckicking before the swap. brand new battery, and there are two plugs behind the engine near the firewall that arent plugged into anything but dont seem to have a place to go. I left harness intact before i swapped the motor

also no blown fuses or relays.

clutch pedal starer wire up by fusebox

which fusebox? annd it was an auto==>> manual swap if that makes a difference. oh and clutch slave cylinder currently isnt mounted to tranny

there was a relay mising the n&p clutch relay. plugged it in but no success.

Im still stumped, anybody have any ideas?

a new key!

what do you mean a new key?

so it was running before? the 5 speed swap had already been done?
(I think he is joking about the key)

did you hook up the starter signal plug

Need more details!!!
Ok, your starter work?
Do you even have power at the starter?
Just because the wires are connected, don't mean sh!t.
MORE INFO!!!

does anybody know what it is?

Take a bunch of photos of your engine bay and post them to this thread, try not to be so stupid on the internet and give more info. DERP

Find your wiring schematic for the starter circuit. There shouldn't be much in between the battery and the starter. Typically the ignition switch, starter relay, neutral safety switch, and a fuse.

werd, take the starter and get it tested, use jumper cables if necessary. Double check all of the connections!

ok, and yes before i swapped the new motor the prev motor before it blew started up with the 5spd swap. the starter worked before. ill double check connections and go to get starter checked.

went to get the starter checked, bad solenoid. So i picked up a new starter and hopefully itll stop raining soon so i can replace it and get the car running

Thanks for all the help

hopefully it works


Posted from Zilvia.net App for Android

still no crank O_o i took some pictures of the engine bay, ill post them in a little. theyre from before with old starter but since that is now replaced with new one it has to be something else

is the starter getting any power ?

how do I check that? well more specifically how would I check that with a multimeter?


Posted from Zilvia.net App for Android