near finished sr swap.. problems

[HyperTek]

Ok so I got the wiring done, z32 maf and plug wired in, z32 fuel pump, s-afc to control it, all vacum lines etc, everytrhing should rock. However, it doesnt seem to fire up. checked ignitor chip, even got another ignitor chip from a friend and same thing, just cranks from the starter but doesnt fire up. Got fuel so thats not an issue. Pulled a coilpack out and stuck a screw driver in it and got it near the chassis to see if it sparks up, and it bearly sparks (not as often as it should). I followed this for the maf plug wiring http://www.az240sx.org/tech/mafs/z32diagram-correct.jpg and followed nissanperformancemagazine's write up on the harness wiring. http://nissanperformancemag.com/march04/240sr/ Anything I should check for? Im all out of ideas.

[nrg]

Check compression, injectors, coil pack, sparks, timing.

[iLL240SkiLLz]

Check the timing on the CAS. That ended up being my problem.

[RpSinner]

id say check the cas also...i had a problem with mine. when i opened up the cover it turned out the disc was cracked.

[HyperTek]

got it running,.. just re-seated the ecu in the harness and changed settings on safc.

Good question tho, how the hell do you check timing on a car with coil packs? I think my friend tried checking it but the timing gun doesnt get a signal from these wires?

[nrg]

there's a black wire loop on the coil pack harness.