View Full Version : PS banjo bolt
iamwesley
01-22-2006, 01:45 AM
Where can I get one with washers?
aznpoopy
01-22-2006, 01:52 AM
junkyard.
nissan dealer.
if you have the bolt, just buy the washers seperately from the dealer.
IAM_SO_sLOw
01-22-2006, 02:16 AM
i say just go to a junkyard and pocket it lol
DoriftoSlut
01-22-2006, 02:39 AM
you can get them at autoparts stores cost. cost is low and its brand new.
kingsol
01-22-2006, 02:42 AM
i believe the dealer charges $60 for the bolt alone and a stuipid dumb amount for the washers which you could get from home depot. i remember asking for two bolts for the pump and misc. nothings and they charged $180...
Suk02Si
01-22-2006, 04:36 AM
For which motor? The mount for the dohc was diff than the one for th SR
http://teamstealthonline.com/images/misc/s13/swap34.jpg
The one off my SR (left) has a slight angle to it. I have the stock dohc one (right) if you need it.
kingsol
01-22-2006, 09:18 AM
they both work with the sr pump
sidious141
01-22-2006, 09:19 PM
i say just go to a junkyard and pocket it lol
2nd that, just make shure you hide it well
FRpilot
01-23-2006, 04:07 AM
if you have the bolt, just buy the washers seperately from the dealer.
aren't the washers thin copper washers? only dealer sells these?
projectRDM
01-23-2006, 08:14 AM
aren't the washers thin copper washers? only dealer sells these?
No, as mentioned above any auto parts store will have them in numerous sizes.
aznpoopy
01-23-2006, 09:15 AM
from my understanding the washers are a 'special' size so when you torque down the bolt, the opening in the banjo bolt aligns properly.
after doing it... IMO if you get any old set of washers, you could probably just overtorque the bolt a little to get it to line up properly.
Dousan_PG
01-23-2006, 11:41 AM
not true
i used autozone ones and its fine. no leaks
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.