PDA

View Full Version : sr20det swap questions


nissanguy13
12-29-2005, 03:01 PM
im down to only a few things left before i can start my sr up. ive been searching and looking at pics. but still cannot figure out where the four vaccum lines that are next to the ignitor chip run to. also the wastegate and the the blow off valve have vaccum line that runs somewhere, but not sure where. i cant seem to figure it out becuase there are no lines left. i ran the two lines near the throttle body to the stock ka plastic cylinder that sits next to the driver head light. i believe that is correct if not please let me know. also i have two electrical connectors on the driver side that im not sure if the are still needed. one runs under the power steering resevoir, it runs with the a/c connection, and the other is close to it on the same side. i think that it went to the ka p/s pump but cant remember. and i dont have my ka here to double check, and no other connectors left to connect them to. also do i have to have the o2 sensor in the turbo elbow to make the car run properly, or can i leave it capped off like it came? (its the megan one with the bolt already in that hole). any help will be greatly appreciated

CarloSR
12-29-2005, 03:07 PM
http://www.sillbeer.com/vaccum.php

nissanguy13
12-29-2005, 03:25 PM
carlossr thank you for that site. it was exactly what ive been looking for. question though, the canister for the ka vaccum lines. im not sure what its called but it sits on the driver side behind the headlight. it sounds like i dont need it? should i take it out, or does it still have a purpose?

nissanguy13
12-29-2005, 03:25 PM
is that cylinder i was taking about, the carbon canister?