Car won't start after replacing harness

[Jeff240sx]

So.. I removed my JWT/50# setup to install an Enthalpy tune and Nismo 740cc injectors, along with a z32 maf.
I used a '95 OBD1 harness on my OBD2 '96, and replaced the TB and TPS with a '95 OBD1 unit.
I rewired the maf plug, the coolant temp sensor ('95 was different plug, same wires), and the large plug on the distributor because it was crunched up on the donor harness.

Currently, the car just cranks and cranks and cranks.. never tries to fire up. I can't tell if it's missing fuel or spark, but I'm not hearing the injectors (although I have a very loud pair of fans that drown most noise out).

Anyone have a clue of something I'm probably missing? Or things to look for tomorrow when I go back out there?
-Jeff

[Ritz S14]

Start with the basics.

Before you can even begin to do anything you need to check:

Fuses
Spark
Injector pulse
Grounds

Reread your post. TRIPLE or QUADRUPLE check your wiring at the ditributor.

Also, if you've removed the distributor, make sure you line the distribuor up with the #1 cylinder.

[Indolent]

Also, if you've removed the distributor, make sure you line the distribuor up with the #1 cylinder.

What he said