injen CAE

[project_240]

i got the intake part in just fine...but the CAE looks like you have to cut a part of the engine bay to make the pipe fit. anyone know if this is necessary? and if not, how the heck do you fit that thing in that small hole??

-jake

[9524tee]

take off the resonater box ... then there will be a hole there , apply the tubing in that hole , place filter on pipe below ... kapeesh?

[fadenb]

thats right but dont forget to remove te tire and the fender guard. You might want to replace it if its in bad condition before the rain comes again. I got water all over my filter from the tire spin and put out the spark. replaced the cover and no more problems.

[s13silady]

after you remove your wheel wells, there should be couple bolts holding down your resonator.... after you take those bolts out there should be hella room in the engine bay.... but you might have to make the hole a little bigger......so that the cold air tubing will fit...