Getting the top starter bolt off...?

[Neejay]

That damn top bolt...jeez...its such a tight fit, I tried using 2 extensions locked together, but it was so loose I couldnt get the wrench to lock enough to turn (not to mention the tight fit).

Whats the trick to removing the top bolt? I also couldnt access it from the top.

[-usmd-180sx]

You can use numerous things to get that bolt off. I used just a standard socket ratchet. Dont use any extensions, it wont fit. Obviously. But ya.. try using a 1/4 ratchet with a regular bolt to loosen it.. and then slip a open end wrench in there to take it off.. It helps if u have the wrench that has the turning ability. (know what i mean?)

Try that and get back to us :wiggle:

[Jonnie Fraz]

I used a u-joint socket and extension and had no problems. Use name brand socket ie. Snap On, Mac, or Craftsman You will save yourself a headache.

[Xren17]

I bought extra long wrench from freight harbor for $10.

[pr240sx]

Wooble adapter, long extension, from the tranny.

[S13Disco]

long extensions to reach from behind the tranny plenty of room to use a 1/2" ratchet back there :squintd:

[Tenchuu]

you with ratchet pushing, friend with long wrench hooked onto wratchet pulling from other side. it comes right off.

[bardabe]

Dude just jack up the car abotu 1.5 feet in teh air. put on good jackstands and have fun. I took off the starter from my car in less than 20 minutes from UNderneath the Vehicle. :Ownedd:

[240silvia]

Jack the car up. Link about 4-5 12" extensions together. Fish it in from the trans. It's easy. 5 mins and you will be done.

[ledzeppelin240]

Yeah about 1.5ft of extention on the side of the tranny, used a 1/2 inch drive ratchet and wooble adapter, had it off in 5min.

[NemeGuero]

I dunno about 1.5ft.. I had 8" tops.. and I had it off..
Wobble socket and extensions. That's it.
OR
You can pull off the intake mani and reach from up top. It's a clear shot.