Recent drag race video :)

[[email protected]]

In car and outside videos from last week (launching sideways is fun):

In car video (http://www.splparts.com/events/sar1105/kuah_incar.wmv)

Outside video (http://www.splparts.com/events/sar1105/kuah_outside.wmv)

Timeslip for this run:

http://www.splparts.com/events/sar1105/1101.jpg

Finally cracked 10s on the 2nd run:

http://www.splparts.com/events/sar1105/1098.jpg

All this on my daily driver Z that I also track regularly at HPDEs (just attneded one at TWS the week before) :) Goes to show you can setup a car's suspension and drivetrain to be good at both road racing and drag racing...

Well now I gotta finish building my S13, just need money for the fuel cell, seats, cage, etc :)

[whitey240]

pretty sick man, that launch looks like fun

[mr_240sx]

nice video man!

[420sx]

nice times man. what mods do you have?

[ThatGuy]

Nice run Kuah! Can't wait to see the S13 too.

What Mods?

-------Taken from SPL Parts.-------
http://www.splparts.com/About/KuahZ32/kuah2.jpg
Engine/intake/exhaust

Motec M600 standalone
Innovate Motorsports wideband O2
SPL twin S15 turbo kit
Custom exhaust - coming soon
ARC M105 twin intercoolers
ACT clutch
HKS SSQV blow-off valves
SPL/McCulloch Howe radiator with full-flow oil cooler/heat exchanger
SPL custom radiator ducting
SPL radiator air guide
SPL radiator pipe kit
Gonza coolant catch tank
SPL custom recirculating oil catch can & crankcase vent

Suspension/handling

SPL coilovers
SPL tension rods
SPL front upper arms
Okuyama rear strut tower bar
Stillen sway bars
SPL rear sway bar endlinks
SPL front fender brace
Do-luck rear ladder bar
Tomei 2-way clutch-type LSD
Nismo differential mounting bushings
SPL subframe bushing collars
Nissan/Brembo Skyline GT-R (R33) 4-pot Brembo front calipers
SPL custom titanium brake pad backing plates
SPL Skyline GT-R (R33) 2-piece 12.8" front rotors
SPL brake lines
SPL custom brake cooling ducting
Nismo brake deflector duct
SPL brake proportioning valve
5Zigen FN01R-C 17x9 front and Gram Lights 57C 17x9.5 rear
Weight reduced to 3285lbs (fuel tank needle at 3/4 mark)

Misc bits

Reactor 24lb battery
Flaming River battery disconnect switch
Summit Racing 1ga battery relocation cables
SPL clutch line kit
Aeroquip custom stainless braided fuel lines
Aeromotive fuel filter and fuel pressure regulator
Speedbleeders
Defi BF boost gauge
Defi VSD concept
Nismo GT shift knob
OMP quadro steering wheel
Nismo steering wheel button
CMR steering wheel hub
OMP pedals
Nismo oil cap
Nismo radiator cap
Nismo fuel cap

[gmckey]

god I love that car! It's so subtle and amazing haha!

[Nostradamus]

That is some sick 60's. On the second race you had the dude by .4 and he still ran a 9.7. :eek: What was it a Supra with a snail the size of my head?

EDIT: I just looked at his trap :tweak: and I doubt it's a Supra but none the less he should've ran a high 8.

[[email protected]]

nice times man. what mods do you have?

Woops that page on the site has not been updated for over a year now, mainly the rear suspension has been upgraded:

SPL aluminum subframe and diff bushings
SPL reinforced subframe
SPL traction rods
SPL rear upper arms
SPL toe arms and Hicas-to-toe arm conversion bar

The suspension mods kept the car tracking straight even on low tire pressure, and reduces scrub; the stock suspension had quite a bit of play which allowed small toe changes.

Also running M/T ET Streets, race gas, 2 step rev limiter, 20 psi boost.

[[email protected]]

That is some sick 60's. On the second race you had the dude by .4 and he still ran a 9.7. :eek: What was it a Supra with a snail the size of my head?

EDIT: I just looked at his trap :tweak: and I doubt it's a Supra but none the less he should've ran a high 8.

It was a bike :)

[Nostradamus]

It was a bike :)

Dammit I should've known. Nice runs.

[240SeXy!!]

haha yea nice one! :faint:

[Angel]

That thing is hooking for sure and the driver is getting it done ! Congrats.

[EchoOfSilence]

z32's have HUD's? i did not know...

[240meowth]

z32's have HUD's? i did not know...

i know, i was going to comment on that, HUD in middle? is that like oem stuff or aftermarket?

[[email protected]]

z32's have HUD's? i did not know...

Its the Defi HUD (VSD Concept)...

[sLiDewAys]

wabbam. this is why we buy spl parts. PROVEN once again. hey kuah. thanks for the kts coils n spacers. will order from u again. k bak on track.

whats left for the s13?

[NI_YON_Zenki]

YEEEAUH MUUUFUKKKA. .. .. YEEEAUH. .. .. Can't knock the Z shootin fat booty clouds. .. .thuttin' flames at 110mph. .. . Keep that car smooth KUAH, much Love duke

[2iv0 sx]

:eek: at that launch!
cant wait till that s13

[[email protected]]

whats left for the s13?

The chassis is stripped and the next step is the fuel cell and cage, then custom chassis wiring, and suspension bits of course :) Then a S14 blacktop SR20DET that has been waiting to go in for 1.5 years now :/