PDA

View Full Version : As the wheel turns...


BigNick8504
09-14-2005, 01:37 PM
I am trying to figure out if it is possible to run 17x10 fn01rc's on the back of an s14 that is lowered approx. 1" without doing more than rolling the fenders. And if so what offset is needed? I would like the edge of the rim not to stick out beyond the fender line.

2JZGTE
09-14-2005, 02:08 PM
I can't give you exact offsets but almost positive 17x10 can fit with just rolled fenders.

I have 17x10 +10 on the rear of my S13. To fit I pulled my fenders about 15-20mm. Camber is around -1.5

Good luck, I'm sure someone else on here can give exact offsets for your 14.

Billy

nrg
09-14-2005, 02:14 PM
I'm running 17x10 +12 on the rear of my s14. the rim is sticking about an inch pass my fender line. I had to do a small roll and my car is dropped about 2 inches. I still need to drop it one more inch.
I would suggest getting +25 offset and using a 5mm spacer. It will get the wheels FLUSH to the fender and might clear coilovers.
http://www.phihoang.com/img/misc/s14/wheels/IMG_1779.jpg

orion::S14
09-14-2005, 06:56 PM
If you want to run a tire that's appropriate for a 10" wheel (i.e., 255 as a MINIMUM)...then a 17X10, +35 will fit perfect. May require a *minor* roll from a rubber mallet, but that depends on camber.

- Brian

Dousan_PG
09-14-2005, 09:37 PM
i run 10 +20 on the s14 with about -1.3 degreess camber. fenders pulled slightly
235 (going 255 or 245 soon) 17" wheel

nearly PERFECT
with a fender roll and slight pull.

but brian has the setup if you dont wan tto do either.