no9to5r
09-11-2005, 01:16 PM
I just finished putting an S13 SR20DET into a 1996 S14. I have a Greddy multicontroller and 2 electric fans. The Greddy shows 170 when the thermostat opens. My oven thermometer also read 170 when placed in the radiator, but the S14 gauge reads 1/4" from high. Is the this fault of the S13 temp sensor for the gauage cluster (2 wire) not being calibrated to the S14? Should I try to swap the S14's temp sensor since the ECU does not read this one?
The speedometer reads 90 when I am going 40 (per the Greddy controller). I thought about swapping the speed sensor from the KA's tranny, but the ECU definitely needs this signal. Oh, and the odometer spins really fast also.
Any ideas on how to make the speedometer work?
I was ble to keep the EVAP and AIR system with some copper fabrication. Also fabricated a 3 way pipe to connect the turbo cooler, engine and heater core so I don't have hoses running all over. Thanks.
The speedometer reads 90 when I am going 40 (per the Greddy controller). I thought about swapping the speed sensor from the KA's tranny, but the ECU definitely needs this signal. Oh, and the odometer spins really fast also.
Any ideas on how to make the speedometer work?
I was ble to keep the EVAP and AIR system with some copper fabrication. Also fabricated a 3 way pipe to connect the turbo cooler, engine and heater core so I don't have hoses running all over. Thanks.