PDA

View Full Version : 1997-1998 H1 Headlamp/10.5 inch wide rear wheels

BoLLeH
09-06-2005, 07:10 PM
Hello,

I was wondering if anybody knew where I could get the H1 connectors for the 1997-1998 headlamp assembly. I've asked a few car audio shops and they were all clueless. My car is currently undergoing a facelift and should be done in two weeks so hopefully, someone will guide me to a place.

Meanwhile, I had another question which is regarding the rear wheels. I am planning on ordering 18"x10.5" +18 Volk Racing CE28N to be used as my rear wheels. I was wondering if someone could tell me how much minimum additional flare I would need to fit these wheels? I plan on running Tein Circuit Master RA's (because they feel great) and Greddy's GREX 4-Pots in the rear. I am not going to pull or roll my fenders but am looking at the 30mm, 40mm, or 50mm overfenders which are out there, since my car is already in the shop.

I believe that those are my only two questions. Thank you in advance for your response. If I have aggravated any of you for perhaps posting in the wrong section or asking a common question, sorry. I am in a real rush and have tried searching and calculating. I kind of don't trust myself. =))
speeddreamz
09-06-2005, 09:57 PM
Your overfender issue is dependent on the flushness wanted , some ppl like it tucked a little, some like it mexican style, some like it inbetween somewhere. I know that if you pull your fenders, you can get fno1rc's with +15 on a 10 inch rim to fit. Also, it depends on your tire size for fitment ...most ppl will have to run stretched 245's or 255's
BoLLeH
09-06-2005, 10:16 PM
Your overfender issue is dependent on the flushness wanted , some ppl like it tucked a little, some like it mexican style, some like it inbetween somewhere. I know that if you pull your fenders, you can get fno1rc's with +15 on a 10 inch rim to fit. Also, it depends on your tire size for fitment ...most ppl will have to run stretched 245's or 255's

thank you for your response. I am trying to make it as flush as possible. I initially was aiming for 10" wide wheels in the rear but Volk doesn't make the CE28N's in 18"x10". I am actually just trying to get as much traction as possible. WOuld you happen to know if 18"x10.5" +18 CE28N's would fit in the rear with complete flushness on a 30mm overfender or would I have to upgrade sizes to the 40mm or 50mm? Thanks once again.