z32 rear calipers (alum) w/rotors drilled for 4-lug (and 5)

[jtt220]

z32 aluminum calipers, no leaks and very clean, with stock rotors redrilled to 4 by 114.3 for all you 4 luggers out there. Calipers have all hardware needed and decent pads; this is a "bolt-on" affair.

Price- best offer by this weekend (PM me or post them)

I will ship for a very reasonable rate and package them up good.

[jtt220]

no offers at all? If $100 is the highest I get then I will sell them, just want them gone!

[Monooxide]

Rear calipers and they bolt on to the Stock S13 hub? Are they 30mm or 28mm?

[theicecreamdan]

I dont think rears came in 30 or 28mm,
weren;t the rears the same on all Z32s anyways?

[jtt220]

All the same two piston calipers on all z32s. These are aluminum and came off the same car I got my front 30mm from (not that it matters). They bolt right up to the stock s13 hub, Monooxide.

[GLoBaLReBeL420]

Pm Sent . . . . . :werd:

[stp9154]

Have they been sold yet?

[jtt220]

available untill Saturday. I have three offers for $100 so I gues if someone else wants them offer me more than $100. I will sell to the highest offer on Saturday. If someone wants them now I will do it for $130. Great deal if you think about, especially if you are 4-lug!

These have All hardware and pads with much life left. I can turn the rotors down for free if the buyer so desires, but they really don't need it yet. These can be bolted on as-is.

[jtt220]

bump...one day left! Going for $100 right now...

[jtt220]

bump...going once...going twice....

[nlzmo400r]

just remember that the 300zx uses a drum style ebrake, so putting these brakes onto your s13 or s14 without also swapping over the ebrake assembly will render your current ebrake useless

[91CRXsiR]

where are you located?

[jtt220]

I am in Michigan but will ship for $10.

The comment about the ebrake assembly is correct. I figured everyone knew that. I just sold my e brake assemblies for $85, I am sure one could find a similar deal.