nismoman91
08-24-2005, 11:36 PM
Well im in the middle of a DOHC swap into my 90 hatch and the motor is in and im strating to run the harness now. Now my question is, as posted on Zilvias DOHC swap guide there is this point near the bottom:
"Locate the body harness (under dash harness that attached to the ECU) that attached to your old harness. Cut the old connector off (the one that attached to your SOHC harness) and attach your DOHC body harness connector. Just match the colors! There will be some wires left over. These are for the SOHC's diagnostic plug, and are unnecessary. Please note: Your car will NOT be able to hook up to a CONSULT tool. To accomplish this, you must get a body harness with all the correct DOHC wiring. This is why we cut the body harness connector off, and not the engine harness connector."
Now I went to the wrecker today and got the ECU connector and a different one. Which one is the correct one I need to wire in? Or did I fail misserably and neither are right?
http://img.photobucket.com/albums/v635/nismoman91/Picture003.jpg
Thanks for the help.
"Locate the body harness (under dash harness that attached to the ECU) that attached to your old harness. Cut the old connector off (the one that attached to your SOHC harness) and attach your DOHC body harness connector. Just match the colors! There will be some wires left over. These are for the SOHC's diagnostic plug, and are unnecessary. Please note: Your car will NOT be able to hook up to a CONSULT tool. To accomplish this, you must get a body harness with all the correct DOHC wiring. This is why we cut the body harness connector off, and not the engine harness connector."
Now I went to the wrecker today and got the ECU connector and a different one. Which one is the correct one I need to wire in? Or did I fail misserably and neither are right?
http://img.photobucket.com/albums/v635/nismoman91/Picture003.jpg
Thanks for the help.