Turbo Info?

[Silvia240sxxx]

I'm looking in on getting a turbo for my KA24DE. I'm going to most likey buy all the parts seprately because of the high price of buying a whole kit. Also that way I piece the turbo system together the way I want it.

I'm just not sure where to start. Do you guys know any good set-ups? What are all the parts you need to have the turbo run. As far as I know, I beleive you need to get a turbo, turbo madifold, Fuel Controler, Oil lines, and it's probably good to get some bigger injectors, I also want to get an intercooler and then Id have to get intercooler piping. What else would I need? Any other help would be appreciated. Thanks in advance guys

[S14DB]

http://www.zilvia.net/f/showthread.php?t=62609

[mixxamike]

Hey, i'll post for you cause I really cant post in the FAQ section yet (my KA-T is not running or even put together yet). But here is a list of my mods either in the mail or at my machine shop.

S13 KA block hot tanked, decked, bored .02" over,
shot peened stock rods
Arias 8.8:1 pistons 89.5mm
Cometic MLS HG .054"
ARP head, main, rod fasteners
ss oil lines
Phat KAT manifold/DP
PK GT32 .63 ar turbo
tial 38mm wastegate (.8bar spring)
z32 mafs
550cc sidefeed injectors
spec stage 3 clutch
HKS ss bov
Enthalpy tune
ferra valves
factory replaced timing kit, water and oil pump
ssac 3" exhaust
walbro 255lph fp


my intercooler and piping have yet to be purchased but a sponsorship is in the works. oh, and i also need to think about an oil catch.

With this setup and the enthalpy tune i'm shooting for around 350 RELIABLE daily rwhp. Hope that helps you out.

[Mervyn]

did you check out the FAQ section above for the KA?

[96twofourty]

maybe searching or just reading the damn sticky would help......

[Silvia240sxxx]

mixxamike: Thank you for the info. It did help a lot.

The rest: Thank you for leading me to the FAQ. That has a lot of info in that thread.