PDA

View Full Version : To much smoke to see


flyingfaqhS13
06-28-2005, 04:29 PM
I have a serious problem with my 91 240. The ka24e shot a rod and i took out a ka24de out of my wrecked 93. the swap went nomal until we started the car. The engine hasn't run in 3 years so a little smoke was expected. This car is burning richer than a gas can on fire. We replaced the MAF hoping it might have been damaged in the wreck. The timing is correct, the injectors, rotor button, cap, plugs and wirers are all new. This damn car still won't run well unless its at wide open throttle. It stalls after a few minutes of running and won't accelerate. There is no such thing as driving at half throttle without neck-breaking hesitation. Please some have a better idea than pushing it off a cliff.

96twofourty
06-28-2005, 05:03 PM
maybe your injectors are bad? Have you removed the spark wires one at a time to see if there is a bad cylinder?

Drunk Bastard
06-28-2005, 08:22 PM
sell your s13 and buy a turbo II

Andrew Bohan
06-28-2005, 08:29 PM
lol joe, that doesn't work for everyone.

mrmephistopheles
06-28-2005, 09:46 PM
...my 91 240. The ka24e shot a rod...

Something is not adding up here.

flyingfaqhS13
06-29-2005, 06:11 PM
There is good fuel pressure at the rail and there is good compression on all 4 cylinders. I'm stumped so far.

flyingfaqhS13
06-29-2005, 06:13 PM
There is good fuel pressure at the rail and all 4 cylinders have good compression. I have pulled the plugs off each injector one by one to see if and injector might be stuck open from sitting for so long and not running. I stumped so far.