PDA

View Full Version : KA Distributor wiring description needed


dwillms
05-23-2005, 05:13 PM
I am looking for a description of what each of the wires are and where they go for the 6-terminal harness that plugs into the distributor. I have searched long and hard, and can't find any info in the FSM either. All it tells me is that it is the "CPS and Power Transistor" harness, not what each of the wires are.

Right now, two of the six wires are cut just after the harness, and I don't know what they are for or where they go. So any help getting this sorted out would be appreciated.

Thanks,
-Dustin

dwillms
05-24-2005, 05:25 PM
bump for anybody who can help me

drew935
05-24-2005, 06:16 PM
On my KADE, there are only 4 wires for the CAS on the distributor. Are these the wires that you are referring to or is it something else. What are the colors of the wires. Please specify... :mepoke:

dwillms
05-24-2005, 07:12 PM
Ok, I found the help I needed on the JWT site. For those in the future looking for this info, here is the link:

KA and SR Distributor Wiring Diagram(PDF) (http://jimwolftechnology.com/wolfpdf/DISTRIBUTOR%20SR%20KA%20CHANGE%20CAR%20TO%20EXT%20 COIL%20AND%20TRANSISTER.PDF)

KA24DE Internal Coil Distributor:


http://img267.echo.cx/img267/6122/distrib3zc.jpg


2-pin Harness (original wire color):

8- (Light Green/Black) Ignition CK From ECU Pin #2
7- (Black/Red) 12V to Power Ignition Coil

6-pin Harness, (original wire colors):

6- (Black) Ground to C/A Sensor
5- (Black/White) 12V+ to Power C/A Sensor
4- (Black) Crank Angle Position to ECU 41,45
3- (White, Shielded) Crank Angle Reference to ECU 40,44
2- (Black) Ground to Power Transistor
1- (White) Ignition Signal from ECU Pin #1

drew935
05-25-2005, 10:57 AM
good find. But my cas only has 4 wires and I have an ext. coil not internal. I believe that your setup may only be in Canada. :mepoke:

idlafie
05-26-2005, 02:58 AM
good find. But my cas only has 4 wires and I have an ext. coil not internal. I believe that your setup may only be in Canada. :mepoke:

No..he's right....USDM S14's use the same setup. It's only the S13's that have the EXTERNAL coil. On the S14's all the coils are internal.
ID

drew935
05-26-2005, 10:32 AM
Ahh I see. He never stated if it was an s14 or 13. But I assumed that all the DEs had ext. coil. I'd rather have an ext. coil anyway... :bow: