silvia hood in a 240

[ITSUMO]

stupid question but will a silvia hood fit in the trunk of a fastback?

[Ian]

probably not...think of the widths

the hood nearly covers the whole rear...while the trunk is about just as wide, the inside of the trunk will be much smaller


if you leave the hatch up and then put it in at an angle...MAYBE

but for good measure i'd just borrow someone's truck or big SUV so it dosent get messed up

[theicecreamdan]

correct, the hood will not, I already tried, and dont use an 88 4-runner, they won't fit in there either.

[IGSDann]

My S14 hood fit in the bed of a 98' Tacoma, barely, but just fine.

[420sx]

just fold it in half and stick it in there.....

[mr_240sx]

just fold it in half and stick it in there.....
:smash: :smash: :smash: :smash: :smash:

[FRpilot]

maybe will fit? but most likely not and only if you can get it in there. i had to tie it to the roof of my fastback. good luck.

[crioten]

nay for fitting it in a durango... cant get mines in there

bah... still need to pick it up

[kazuo]

maybe will fit? but most likely not and only if you can get it in there. i had to tie it to the roof of my fastback. good luck.

http://www.lazypenguin.net/poop/kenny_hood.jpg
http://www.lazypenguin.net/poop/kenny_hood2.jpg

lol

[kingsol]

hahaha! hella ghetto

[crioten]

did the airport clear you for takeoff with that wing? lol...

[240trainee]

Yea, strap it to the roof. thats what I'd do

[MakotoS13]

laying it upside down is pretty fuggin stupid. its best to put some towels on your roof, lay it down, then strap it down.

[Dutchmalmiss]

i fit a usdm s13 hood in my trunk with the trunk still a little open. i had to tie it shut. don't know if that helps.

[sideview_180sx]

stupid question but will a silvia hood fit in the trunk of a fastback?
http://i2.photobucket.com/albums/y34/revat619/poser.bmp
get a tape measure and spend 2mins taking measurements then waste however much time it too you to long onto zilvia

[Ian]

yeah, the silvia hood is gonna be the same dimensions up top as a US hood


and a S14 hood WILL fit in the back of an element...actually, the entire cosmetic front end of an S14 will (headlights, bumper, hood, fenders, grille) easily

[420sx]

:smash: :smash: :smash: :smash: :smash:

u didnt realize i was being sarcastic? :cj: :fawk: :loco: u must really be stupid just like the guy that started this thread with idiotic question

[Dutchmalmiss]

and a S14 hood WILL fit in the back of an element...actually, the entire cosmetic front end of an S14 will (headlights, bumper, hood, fenders, grille) easily

i love those elements!

[Andrew Bohan]

i fit a fastback hatch lid in the back of a fastback.
http://www.geocities.com/imadriftaholic/car/uhoh.txt