z32 rear hubs NA Vs TT?

[rrobe99999]

I'm gathering parts to do the Z32 rear brake conversion on my 95 240SX SE. I picked up the parts at the junkyard, and after taking them apart, I realize I have different hubs for left and right. One hub has a larger hole for a thicker axle. I'm assuming this is from a TT Z32. It also has the extra flange and hole that the E-bake bolt goes through. The other hub does not have the extra flange, and has a smaller hole for the axle. I'm assuming this is from an NA Z32. Which hub will fit the axles on my car?

[sw20>>s14]

so your assumptions are correct, tt has larger shaft holes. only na will fit

[rrobe99999]

Thanks for the help. That's what I was thinking. The article I read on sportcompactcarweb.com must be wrong. It says they used TT parts. Just goes to show that Zilvians know more than the magazines.

[ultraDorksGarage]

didnt know that too, good to know^^