PDA

View Full Version : Gauging interest: KA24E turbo manifold and KA24E/DE turbo kit parts


brokeAs240sx
01-05-2005, 04:27 PM
Hey guys,
I'm planning on switching up my turbo kit so far (have not installed it, parts are used from previous sellers but in very good condition). I plan on going externally wastegated and equal length manifold (if this stuff sells) - prices are picked up, will ship if interested:

1) SOHC Iron-cast manifold from Realnissan - egt port, no wastegate flange - IRON CAST! - $400
2) T3/T4 Garrett Turbocharger w/ internal wastegate - no shaft play, good condition - believe it is .60 A/R or trim, can verify - $400
3) Starion FMIC w/ intercooler piping and couplings - $300
4) Partial downpipe for turbo (has 3 bolt flange for downpipe, nothing for turbo end - I have the flange too if interested) - $50
5) CA18DET Top Feed 370cc injectors - offer (I may keep these)
6) oil feed / return lines - offer (probably keeping these, too)

I'll have pictures up later if anyone is interested.

I also have:
1) 17" Katana Rims :-D - $350
2) Tenzo 350mm Turismo Steering wheel - red center - $80
3) SOHC OBX radiator hose kit (upper & lower) red - new - $30
4) 32mm water temp gauge sensor adapter for radiator hose - new - $25

Please email me if interested - for some reason "instant email notification" doesn't always work w/ me: hyphendesigns AT yahoo DOT com
aim: agentsonic02 - post or email me your sn bcs I block all non-buddies.

Location: LA/OC area of California

It's ok if these don't sell, then I'll just keep my kit, but if you are interested, by all means contact me.