Xcessive ka24de turbo manifold, t3/t4, downpipe and tial wg

[spooled240]

-Xcessive top mount t3 manifold ceramic coated (thick wall, no cracks, version 2) clears hood with t3/t4
-3 inch downpipe from 5-bolt ford housing to CAT
-Ebay t3/t4 57 trim .63 A/R stage 3 turbine wheel rebuilt with genuine Garrett bearings and seals. No leakes or shaft play. Will throw in extended billet -10 AN oil drain flange.
-Tial 35mm external wastegate with 15 psi spring. Will include green spring also which I believe is 8 psi.

Solid setup for high HP. Take it all for $750 picked up in Ramona, CA. I can include a few extras such as a 3AN oil feed line, intercooler piping and a Synapse BOV for the right offer.

https://uploads.tapatalk-cdn.com/20210114/e7ff799c2900b82887362ff08c4dafa2.jpg

[street240sx]

Damn wish I was closer, I would pick up that manifold

[spooled240]

Damn wish I was closer, I would pick up that manifoldI was hoping to sell everything as a package deal, but I decided that I would sell the manifold and the upper half of the downpipe for $550 plus shipping and paypal fees. I can use the lower half for another project and this will cut down on shipping costs significantly. The dp would be cut right above the bend(think of the location of where the 3 bolt flange of SR downpipe)

[street240sx]

I was hoping to sell everything as a package deal, but I decided that I would sell the manifold and the upper half of the downpipe for $550 plus shipping and paypal fees. I can use the lower half for another project and this will cut down on shipping costs significantly. The dp would be cut right above the bend(think of the location of where the 3 bolt flange of SR downpipe)

Wonder what shipping would be. I'd be fine with the dp being cut down

[spooled240]

Wonder what shipping would be. I'd be fine with the dp being cut downPm'd

Msglength

[spooled240]

Bump! ......