new issues

[the head]

I finished the wiring for my haltech yesterday and i was zeroing the timing but i am getting erattic readings from the trigger (CAS) keeps jumping around going from 10deg all the way out to like 50 (way past timing marks) and back

i take it that this is my cas going out but figure if anyone has other suggestions of possibilities to throw them out there

[Kid Zelda]

Did the Haltech not come with a new trigger ?


Anyways, start off by checking the power supply.

W/ Key ON engine OFF, check terminal B and ground .. should have batt' voltage.

Now check the ground, Turn ignition OFF.

Check terinmal A and engine ground .. you should have continuity.


more later, g2g

[the head]

haltech is setup to use the factory cas as the ignition trigger