PDA

View Full Version : CA LA: 180sx Low Mount Spoiler - Also fits S13, S14, Z32, etc

95KA-Turbo
09-17-2018, 08:24 PM
Name: Stephen
Location: West LA
Price: SOLD SOLD SOLD SOLD SOLD

Item: Unknown brand spoiler for 180sx/240 hatch. I imported this wing from Japan in 2009 and have yet to see another one. This wing looks very similar to the veilside wing but has some distinct differences. It sits slightly higher, has a different overall shape, and lacks the hole where the antenna goes - all of which I believe make it look better. This spoiler does not need holes to mount. It comes with C clips and hardware that wraps around the trunk/hatch lid and tightens down with small threaded hex head rods. See the photos below for fitment and appearance.

http://i68.tinypic.com/23l0duh.jpg

http://i66.tinypic.com/346b2tc.jpg

http://i66.tinypic.com/2dhbc4i.jpg

http://i67.tinypic.com/2chrwub.jpg

http://i68.tinypic.com/28b61bp.jpg
speedgod^s13
09-17-2018, 08:37 PM
Do you have a straight on shot of the back?
95KA-Turbo
09-17-2018, 10:18 PM
Do you have a straight on shot of the back?

Here are a few other angles, from before it was green:

http://i68.tinypic.com/acfvc8.jpg

http://i63.tinypic.com/2d0km7l.jpg

http://i68.tinypic.com/kevt79.jpg
brndck
09-18-2018, 02:05 PM
dope wing and good price. too bad it wont clear my fenders
speedgod^s13
09-18-2018, 05:39 PM
dope wing and good price. too bad it wont clear my fenders

I'm stupid that I didn't even think of this, until you said something. I would have been screwed, because I'm going wide body too. Such a dope wing though!
alexnumberone
09-18-2018, 08:53 PM
any pics of how its mounted?
95KA-Turbo
09-19-2018, 08:25 AM
I'm stupid that I didn't even think of this, until you said something. I would have been screwed, because I'm going wide body too. Such a dope wing though!

any pics of how its mounted?

dope wing and good price. too bad it wont clear my fenders

http://i64.tinypic.com/sxgmxk.jpg

Because of how it mounts I believe there’s enough wiggle room to cut some foam and raise the wing to clear over fenders. The metal bracket has threaded rods that tighten down to the underside of the hatch/trunk. I haven’t run it on a car with overs but the fenders aren’t real thick up where the wing goes. If anyone is local I’m happy to test fit it.
Thursday7
09-20-2018, 12:09 PM
is that one pic from the State College PA Oval?
86is300
09-20-2018, 12:12 PM
the way this mounts is GENIUS!
keepinitpignose
09-20-2018, 01:37 PM
This is sharp, I dig the look
95KA-Turbo
09-25-2018, 11:05 PM
Bump, kind of can’t believe I still have this.
alexnumberone
09-26-2018, 12:17 AM
Dm'd you on IG.