PDA

View Full Version : TX Fresh L33 for Boost; Sikky Oil Pan with Remote Filter Setup


2muchboost
04-15-2018, 03:25 PM
Please lock this up. Will create new thread with updated parts.

Fitelite240
04-15-2018, 10:00 PM
No way! What?! How?! Why?!?!

2muchboost
04-16-2018, 06:27 AM
Haha not sure if its a troll but again I have to pay back Uncle Sam some decent cash. Instead of letting this sit for a while and risk getting rusted I would rather pay this debt off and work on my spare setup. Parts, machining, and labor to replicate puts you in the $3,200+ range so keep that in mind. Whole setup has 0 miles. If the buyer is interested I may sell my 80mm GT45 with it.

Fitelite240
04-16-2018, 06:38 AM
Damn I really wanted to see this thing in action. Good luck man. Someone buy this and take care of this man's legacy.

2muchboost
04-16-2018, 02:31 PM
Me 2 brother me 2. Should have made good power with the 80mm setup. Hopefully whoever buys it puts this beast to good use. Much appreciated!

2muchboost
04-23-2018, 09:11 AM
Turbo added to the mix.

2muchboost
04-23-2018, 07:27 PM
Oil Pan setup sold!!! Anyone need a bad ass lightweight 5.3?

2muchboost
04-25-2018, 12:16 PM
Willing to accept a good 6.0 shortblock or bare block to knock some of the cost off.

2muchboost
04-29-2018, 06:22 PM
Good ol weekend bump on the motor and turbo.

SidewayzAsFck
05-02-2018, 12:37 PM
What brand turbo?

2muchboost
05-02-2018, 11:28 PM
If I am not mistaken its the unit that used to be sold by VS Racing. Its the site where a lot of guys go to get the “sloppy mechanics” parts. Taking reasonable offers.

2muchboost
05-04-2018, 09:42 AM
Just realized I will likely not need my Wiring Specialty Harness if I sell the motor so if the motor is going into an S14 I may be willing to sell the harness along with it for a good price.

afishysilvia
05-04-2018, 10:25 AM
Just realized I will likely not need my Wiring Specialty Harness if I sell the motor so if the motor is going into an S14 I may be willing to sell the harness along with it for a good price.

What specs on harness? Zenki/Kouki? What sensors/connections does it have?

2muchboost
05-04-2018, 10:51 AM
From what I was told when purchased it is for an S14 Kouki, non-abs, T56, 5-pin MAF, Fbody Accessory Drive, AC wiring, I believe I also have the SGI-5 Speedo as well but would have to verify, Fbody sensors. I will only sell the harness if the motor goes. If the motor does not sell then I am going to suck it up and mate this to the T56 Magnum sitting in my garage and enjoy this setup some time in the near future. My KA is healthy with a 144k original miles on the Kouki so no immediate rush for me.

Was looking to be responsible and recoop the money I just gave back to uncle sam.

2muchboost
05-11-2018, 12:10 PM
$2300 is the new price for the motor. Heading out of town this weekend with limited cell service but feel free to shoot a text and I will respond as soon as I get service again.

Keep in mind this is a fresh motor with 0 miles ready for some good boost after break in. The asking price is the low end of just the parts that have been put together for this build.

Cheers.

2muchboost
05-18-2018, 08:33 AM
Bumpity bump on a Friday.

2muchboost
05-21-2018, 08:51 AM
Back in town. New price is $1950 FIRM. Will not budge even one dollar. If this does not sell soon I will start parting out or pull it apart & save it for my future build.

2muchboost
05-25-2018, 11:47 AM
Separating block this weekend seems like I have a buyer for the short block. Will make a new post for the Wiring Specialties Harness if she sells.