PDA

View Full Version : Window wont go up


Manie
01-15-2018, 11:33 AM
92 nissan 240sx vert driver side window wont roll up

Dirk Jan
01-15-2018, 12:04 PM
Ok, thanks for the report.

afishysilvia
01-15-2018, 12:07 PM
Ok, thanks for the report.

:rofl:


Be more specific, have you checked fuses, checked switch for power/ground?

Manie
01-15-2018, 12:11 PM
My bad. Yes fuses are good. How would i check switch if it has power/ground?

[240sx]
01-15-2018, 12:11 PM
Was that supposed to be a tweet?

Sent from my SM-G930P using Tapatalk

OutlawLui
01-15-2018, 12:12 PM
Have you tried turning it off and on again?

afishysilvia
01-15-2018, 12:13 PM
Go through the FSM and find the power wires, everything is here. This is your best friend...

http://zilvia.net/f/showthread.php?t=431245

dorkidori_s13
01-15-2018, 01:48 PM
when was the last time you took out the window switch assembly and tried cleaning the contacts inside of the switches? might wanna start there before tracing wires... those old copper contacts build up with a bunch of a crap over time and just all of a sudden stop working one day. this has happened in almost ALL of my s13s. i took apart the window switches, cleaned the contacts with a soft wire brush and alcohol, reassembled the switch setup and they worked perfectly again.

also, pull your voltage regulator (white box inside the door), take it apart and make sure all of the pins are good near the connector that the wiring harness plugs into... the solders on them like to snap due to age. takes 5 minutes to redo the soldering on the broken ones.

Manie
01-15-2018, 02:17 PM
Ok thanks ill clean the switches and check wires nd hopfully that works

mechanicalmoron
01-15-2018, 05:50 PM
Listen to see if the motor comes on when you hold the button.

If it does, it's torn a particular bushing in the window regulator (and somebody could fix it, but you should probably buy a reman unit).

Manie
01-15-2018, 05:53 PM
I dont hear anything when i try holding down the button to roll it up

mechanicalmoron
01-15-2018, 05:57 PM
I dont hear anything when i try holding down the button to roll it up

Well, then that's presumably not the issue...

Keep diagnosing. Have you downloaded the FSM? You need to read about the car and the systems that you're messing with, then you'll know what you're doing, ehh?

Ilya
01-15-2018, 07:22 PM
Are you talking about quarter windows or door windows?

In any case try using a jumper wire to roll the windows up. If that works then your switch is bad.

Manie
01-15-2018, 07:58 PM
Door window and quarter windows.. the only one that works is passenger window but it goes up really slow

mechanicalmoron
01-15-2018, 08:39 PM
Door window and quarter windows.. the only one that works is passenger window but it goes up really slow


Have you got the FSM yet? You should not be writing anything unless you have read a lot of it. Go get it.