kashira kureijii
02-03-2017, 07:34 PM
For sale is a good condition 4AGZE from an AE-111. This engine is a final gen gze, with the oil squirters and the block ribs and strongest internals. It also has the highest boost supercharger of the GZE series.
This engine was converted to run in an AE86 i think in the early 2000's, don't think it has much wear on it at all, cams looked perfect when I took the valve cover off, oil was fine, and oil pressure looked good while it was running for a short time.
I pulled the engine because I couldn't get it to run, and realized that the under-dash harness on my 86 had burned due to improper insulation by the PO. So theoretically this engine should run fine if you get it wired properly. The wiring harness is a little fucked, so I can't vouch for it being plug and play, you will likely have to trace the wiring etc etc. I had the engine running for a little bit, but it would cut out due to the wiring problems with my underdash harness.
It'd be good to megasquirt it in my opinion.
It also comes with a W-series tranny, which I think is from a toyota pickup, I couldn't really understand the PO as his Cantonese accent was pretty thick. I think he told me the bellhousing was an expensive bellhousing for the W-4A setup. I think it is a Nitekids bellhousing, but there's no markings on it, so I'm not sure.
http://i.imgur.com/NpxqGbR.jpg?1
http://i.imgur.com/ZJgPNy4.jpg?1
For Sale :
AE-111 4AGZE rwd converted (setup for T50 but I'm keepin the T50)
-engine is equipped with a light HKS cam (254 i think)
-just replaced the plugs w/denso platinums when I was tryin to get it runnin
W-series tranny w/NITEKIDS? bellhousing (unknown condition, seems fine though)
Comes with a starion intercooler setup that was setup for the car
comes with an HKS mushroom intake
comes with 6 spare coils (from 7mgte)
brand new aisin clutch setup for a mr2 gze, I dunno if it will work for this application though, I also got a clutch fork and some other tranny related parts that I think are suppoesed to work with that setup but am unsure
I cannot vouch for the condition of the wiring harness, it's kinda tore up, but everything is there
Asking $2100
may be open to trades if it is for NA 16V or 20V engine/parts. I wanna put an NA engine in my 86
Pick up only , this stuff is located in College Station TX, I'm in Professional school, so I really don't have much time for getting it shipped etc. Serious inquiries only please, and I would prefer it if you could pick it up on the weekends as I'm always in school.
This engine was converted to run in an AE86 i think in the early 2000's, don't think it has much wear on it at all, cams looked perfect when I took the valve cover off, oil was fine, and oil pressure looked good while it was running for a short time.
I pulled the engine because I couldn't get it to run, and realized that the under-dash harness on my 86 had burned due to improper insulation by the PO. So theoretically this engine should run fine if you get it wired properly. The wiring harness is a little fucked, so I can't vouch for it being plug and play, you will likely have to trace the wiring etc etc. I had the engine running for a little bit, but it would cut out due to the wiring problems with my underdash harness.
It'd be good to megasquirt it in my opinion.
It also comes with a W-series tranny, which I think is from a toyota pickup, I couldn't really understand the PO as his Cantonese accent was pretty thick. I think he told me the bellhousing was an expensive bellhousing for the W-4A setup. I think it is a Nitekids bellhousing, but there's no markings on it, so I'm not sure.
http://i.imgur.com/NpxqGbR.jpg?1
http://i.imgur.com/ZJgPNy4.jpg?1
For Sale :
AE-111 4AGZE rwd converted (setup for T50 but I'm keepin the T50)
-engine is equipped with a light HKS cam (254 i think)
-just replaced the plugs w/denso platinums when I was tryin to get it runnin
W-series tranny w/NITEKIDS? bellhousing (unknown condition, seems fine though)
Comes with a starion intercooler setup that was setup for the car
comes with an HKS mushroom intake
comes with 6 spare coils (from 7mgte)
brand new aisin clutch setup for a mr2 gze, I dunno if it will work for this application though, I also got a clutch fork and some other tranny related parts that I think are suppoesed to work with that setup but am unsure
I cannot vouch for the condition of the wiring harness, it's kinda tore up, but everything is there
Asking $2100
may be open to trades if it is for NA 16V or 20V engine/parts. I wanna put an NA engine in my 86
Pick up only , this stuff is located in College Station TX, I'm in Professional school, so I really don't have much time for getting it shipped etc. Serious inquiries only please, and I would prefer it if you could pick it up on the weekends as I'm always in school.