PDA

View Full Version : need help car feels slow


Loofee95SE
10-05-2004, 09:24 PM
Hey guys wats up??
I have an oppotunity to install a FMIC and BOV on my car,
I was also installing an SrT25 on my car. but that didn't work out to well ( no boost) so i swap back to stock turbo. Now while the turbo were out I was playing with the waste gate actuator, and spin the actuator rod a few time. ( well i didn't think that it was going bck in -_-" )
after all was said and done.....i took the car out for a ride.......car feels SLOW, boost fine up to about 4K...then it feels like it stop boosting and just pushing HOT AIR!!! and no power past that point.
stock set up feels much better than this...
my question is this: can " spin or turn the Actuator rod effect ne thing??
I didn't think so..but I don't know ne thing"
I know that by upgradeing theIntercooler to a bigger 1 can cause Lag, but this is not lag...it feels almost stock up to the point where..it just quit!! which is around 4K.
And i did also install Blitz Twin SBC Spec R boost controller don't know the set up..and I install it afterward vac line from the actuator go to OUT, and from the turbo compressor go to IN. is that right???


Last.. the HKS BOV i install did not come with the recirculating thingy..and it causeing my RPM to jump up and down from 1000-500 @ idle...neway to correct that problem??
Hope u guys can help me.....I love my car..and its sick right now...
C

statik
10-06-2004, 07:19 AM
maybe the wastegate is stuck open or something. if you fucked up your actuator and the wastegate is left partially open that would cause low boost/power

Last.. the HKS BOV i install did not come with the recirculating thingy..and it causeing my RPM to jump up and down from 1000-500 @ idle...neway to correct that problem??

did you hook up the vaccum line to the BOV?

...shrug, what do i know

97SilviaRB
10-06-2004, 07:33 AM
sounds like you have a leak somewhere. Go back over your work and check everything you did...tighten down all bolts again in case something came loose. Check your intercooler piping and also check to see if you installed the bov correctly...could be leaking

rics*project*s13
10-30-2010, 03:19 PM
i know this is an old thread, but i just bought the same kind from someone, but he didn't have the manual. can some one help me? thanks