PDA

View Full Version : Complete SR or KA Electromotive TEC II setup...


TurboB15sentra
09-28-2004, 05:55 PM
I am selling my complete TEC II setup.. It will come with everything you need to bolt on to your SR motor and go.. Here's what you get..

TEC II 4 cylinder unit

SR crank pulley with trigger wheel welded on and cut in lathe

1/2" magnetic pickup sensor

TIG welded steel magnetic pickup sensor bracket

Intake temp and water temp sensors

3 bar map sensor

0-5 volt o2 sensor and harness

CAS alluminum block-off plate

8.5mm MSD plug wires already cut to length with boots installed

Complete wiring harness, already made up for an SR

Maps for a SR20DET with 96lb MSD injectors and 3 bar MAP sensor on disk, and also loaded into the TEC II


This setup will also work on a KA.. you'll just have to weld a trigger wheel onto your KA pulley.. The wheel is about 40.00 from Electromotive. Everything else will plug right in and work fine. I am asking $975.00 for the entire setup..
Travis

Brian W.
09-28-2004, 08:18 PM
pictures? this has the wintec2 software correct? pictures of it installed on the motor so i migh tell how you made the trigger bracket. Thanks [email protected]

TurboB15sentra
09-28-2004, 11:31 PM
Here's the pics..

http://www.fi-r.com/images/My%20240sx%20Project39.jpg
http://www.fi-r.com/images/My%20240sx%20Project42.jpg
http://www.fi-r.com/images/My%20240sx%20Project40.jpg


I have the unit mounted under the dash on the inside firewall.. However, the harness will also allow you to mount it on the passenger side outside firewall, or fender-well. Sorry, I never took any finished pics of it.. the harness goes through the large hole in the firewall where the factory ECU used to.. It's all wire-loomed and taped up. It fits underneath the intake manifold, and you can't really see much of it at all. I also forgot to mention that it comes with a 0-5 volt o2 sensor and harness.

Travis

Fastback180
09-29-2004, 08:25 AM
Ahhhhhhhh, olde electromotive...those hooligans

TurboB15sentra
09-29-2004, 12:27 PM
Ahhhhhhhh, olde electromotive...those hooligans

huh? Good enough to make 661whp/583ft lbs. :)