PDA

View Full Version : Sr20 wont turn over after sitting 2 months


OutlawLui
07-22-2016, 10:15 AM
Sr wont start after sitting 2 months

http://i278.photobucket.com/albums/kk86/evilpanamajack/Mobile%20Uploads/IMG_20160721_005146_zpsr7hmsxja.jpg (http://s278.photobucket.com/user/evilpanamajack/media/Mobile%20Uploads/IMG_20160721_005146_zpsr7hmsxja.jpg.html)
History;

daily for 3 years after swap. Ran fine, let it sit for about 2 months. now wont start

1. after letting it sit for 2 months while i upgraded some parts i installed a new odyssey PC925 battery, went to turn on the car, and no go

2.Starter started sticking, and would only turn, every 6-8 cranks

3. bypassed starter signal wire, cranked but engine still would not turn over

4. checked relays and fuses. Found Melted EGI PUMP relay

5. checked ecu (code #62) and found pin 36 (Ignition switch) was burned, so i soldered it back

6.Added a gallon of fresh fuel...cranked engine, still nothing.

7. Switched out ignitor chip-nothing

8. Checked CAS- all wires working, signal wire working

9. Checked Spark -all 4 coils sending spark *checked with grounded spark plug

10. Checked injectors-took fuel rail off of manifold. all injectors firing

11. Tried starting fluid while cranking it-still wont turn over


To Do/Check list;

-Check compression
-get new spark plugs
-check engine harness
-try new ecu
-Set car on fire

Any ideas on what to try next or check would be helpful :-/

cotbu
07-23-2016, 12:25 AM
Set engine to TDC and reinstall cas
Is it cranking strong?
Crank with the throttle wide open.
If you mean ether, as starting fluid? timing off or there is no air or compression.

Sent from my SM-N910T using Tapatalk

rawgarage
07-23-2016, 04:51 AM
Jump to set car on fire

zurud
07-23-2016, 11:43 AM
set car on fire . use flame thrower

ultimateirving
07-23-2016, 03:08 PM
sat for two months and was the battery disconnected? was the battery dead when you went to start?

jedi03
07-23-2016, 07:52 PM
Probably low crank amps

rawgarage
07-23-2016, 10:03 PM
New battery bet it kicks over and purrrrs

OutlawLui
07-24-2016, 05:50 PM
Set engine to TDC and reinstall cas
Is it cranking strong?
Crank with the throttle wide open.
If you mean ether, as starting fluid? timing off or there is no air or compression.

Sent from my SM-N910T using Tapatalk

Finally turned over, used starting fluid again with wide open throttle as u said and fought it a couple times till it finally stayed on

sat for two months and was the battery disconnected? was the battery dead when you went to start?
No battery, i removed it before letting the car sit since terminals had crazy build up


-now the starter only works wth bypass switch though