articzap
03-14-2016, 05:37 PM
After getting my recently purchased 5 lug swap, I noticed every bearing was shot as soon as I picked each one up out of the box. Frustrating to say the least.
So I pressed out the front bearings, no big deal. But when I pressed the rear hubs, I noticed that the inside bearing race is machined into the hub.
The question arises, are these hubs essentially garbage now because I can't press on new bearings?
So I pressed out the front bearings, no big deal. But when I pressed the rear hubs, I noticed that the inside bearing race is machined into the hub.
The question arises, are these hubs essentially garbage now because I can't press on new bearings?