MaxTheRabbit
10-19-2015, 07:29 PM
S13 radiator, OE spec replacement, got some shit on it but fins are 95%, no leaks - $50
Braided Stainless Clutch slave line with fire sleeve and crush washer - $20
Altima dual e-fan setup, with wiring pigtails, had to clip the shroud a little to clear my AC dryer, fans work great - $40
ignition coil for SOHC - $10
K&N RX-4730 3" X-Stream cone filter with MAF mounting flange - $35
KA Starter (cranks strong) - $40
oxygen sensor (works) - $10
Number 10 ECU (SOHC KA with manual) - $25
will ship at buyers expense
http://www.prism-industries.com/coil.jpg
http://www.prism-industries.com/intake-2.jpg
http://www.prism-industries.com/rad-1.jpg
http://www.prism-industries.com/rad-2.jpg
http://www.prism-industries.com/clutch.jpg
http://www.prism-industries.com/fans.jpg
http://www.prism-industries.com/catch.jpg
http://www.prism-industries.com/driveshaft.jpg
http://www.prism-industries.com/starter1.jpg
http://www.prism-industries.com/starter2.jpg
http://www.prism-industries.com/o2.jpg
http://www.prism-industries.com/ecu.jpg
Braided Stainless Clutch slave line with fire sleeve and crush washer - $20
Altima dual e-fan setup, with wiring pigtails, had to clip the shroud a little to clear my AC dryer, fans work great - $40
ignition coil for SOHC - $10
K&N RX-4730 3" X-Stream cone filter with MAF mounting flange - $35
KA Starter (cranks strong) - $40
oxygen sensor (works) - $10
Number 10 ECU (SOHC KA with manual) - $25
will ship at buyers expense
http://www.prism-industries.com/coil.jpg
http://www.prism-industries.com/intake-2.jpg
http://www.prism-industries.com/rad-1.jpg
http://www.prism-industries.com/rad-2.jpg
http://www.prism-industries.com/clutch.jpg
http://www.prism-industries.com/fans.jpg
http://www.prism-industries.com/catch.jpg
http://www.prism-industries.com/driveshaft.jpg
http://www.prism-industries.com/starter1.jpg
http://www.prism-industries.com/starter2.jpg
http://www.prism-industries.com/o2.jpg
http://www.prism-industries.com/ecu.jpg