Questions about my multi piece wheels, need some wise guys!

[meximan]

Just had a question, maybe someone can help answer...I have a set of OZ mito however the stamp is shitty to read, need a microscope to make out the numbers...and i realized that today the faces were swapped...

So...the faces say. 17x8.5 et 41 and 17x10 et 45...

however the faces are on the wrong barrels. 8.5 face on the 10", 10" face on the 8.5...

Would this affect my ET #'s?

[spk]

Meximan,

I might change if the "pad thickness" is a low disk, medium disk or high disk. Offset is dependent on the back spacing so if you are swapping out two different disk sizes, your offset will change.

I can't do a full calculation since I don't know if your faces are mounted in the front, sandwiched or in the back.

Best way is to swap and measure (assuming it's not sandwiched mounted).

[Sumslapper]

If the back hubs are different heights, then it will change the offset. (Example is high and low disk). If they are the same height, it should be the same. Here is how you can measure a wheels offset from home.

http://www.griplow.com/how-to-measure-wheel-offset/

[meximan]

thank you both.