aser1z
08-11-2015, 12:04 PM
I have a 1998 240sx LE stock and a 1995 240sx ka24det built. I have swapped everything from the zenki into my 1998 kouki. The only problem I have left is the wiring. The ka24det is OBD1 and of course the chassis harness on the kouki is OBD2. What is the easiest way to go about this? Will it be easier using the kouki engine harness and just swapping over the 1998 240sx throttle body and coolant temp sensor? Can I use the obd1 engine harness and just splice into the koukis chassis harness? the ka24det has a q45 TB and z32 maf and is tuned on an s13 ecu so I also have the obd1 to obd0 jumper on the zenkis engine harness. I was hoping to find a write up on this or pin outs of what I can tap into. I'm sure the question has been asked a lot but I have not found any precise answers with the wiring. Your guy's help is greatly appreciated. Thanks.