PDA

View Full Version : FL G50 Q45 Differential VLSD R200 w/ 6x1 Output Shafts

KiLLeR2001
07-23-2015, 08:55 AM
G50 Q45 Viscous Differential VLSD R200 w/ 6x1 Output Shafts. Works great! Comes with bearing races.

A MUST HAVE WHEN UPGRADING TO STRONGER AXLES!!! IF YOU PLAN ON PUSHING OVER 450HP THIS IS WHAT YOU NEED!

Can be used in conjunction with the driver side Q45 axle and driver side Z32 TT axle and either Z32TT hubs or Q45 hubs.

http://tehl33tsite.com/240sxdd/fs/diffs/q45/g50/IMAG3033.jpg

$350 shipped.

PM for quickest response.
PoorMans180SX
07-23-2015, 02:45 PM
An R200 ring gear will bolt to this? I was under the impression this was an R230, but I haven't messed around with enough differentials to know what swaps.
KiLLeR2001
07-23-2015, 06:59 PM
Yes, this is an R200 VLSD that will fit in any S13/S14/J30 etc pumpkin.
KiLLeR2001
07-25-2015, 11:59 PM
Bump it up!
KiLLeR2001
07-29-2015, 12:55 AM
Bump it up!!
KiLLeR2001
07-31-2015, 01:56 PM
Bump it up!!!
KiLLeR2001
08-03-2015, 07:46 PM
Bump it up!!
TheRealSy90
08-04-2015, 10:04 AM
It's tempting to swap to this for the stronger axles and splines, but losing my clutch type lsd for a viscous holds me back :/
KiLLeR2001
08-04-2015, 02:12 PM
You can always run this for the time being then buy a clutch type LSD that accepts 30-spline shafts. Then you will be able to interchange the shafts between LSD units.
KiLLeR2001
08-06-2015, 11:59 AM
Bump it up!
TheRealSy90
08-06-2015, 12:36 PM
I wonder if this would allow you to use 350z axles since they have the same 6x1 pattern.
KiLLeR2001
08-07-2015, 02:53 PM
Might be possible, you'll have to compare axle lengths.
KiLLeR2001
08-12-2015, 06:45 PM
Bump it up!
KiLLeR2001
08-15-2015, 12:13 PM
$325 shipped! Weekend special!
KiLLeR2001
08-19-2015, 10:32 PM
Lets get this sold!
KiLLeR2001
08-23-2015, 12:29 PM
Bump it up!