3rD GeAr
08-21-2004, 03:59 PM
i have a ka24E motor with approx. 5k miles on it the engine has
JE pistons, rings and wristpins (8.5:1CR)
stock rods shotpeened and polished
Cryoed crank
new clevite bearings
3 angle valve job
new SI exhaust valves
port and polished exhaust side
i am asking $500 because the second cylinder is fried and is going to need new rings other than that it is in excellent condition
i also have a JWT ecu programmed for a turbo KA24ET motor with 550cc injectors, Z32 MAFS, 8.5:1CR - i am asking $300
garrett t3/t04e 60 trim .82A/R - $400
custom uppipe for t3 on ka24e - $180
Thanx
Niko
JE pistons, rings and wristpins (8.5:1CR)
stock rods shotpeened and polished
Cryoed crank
new clevite bearings
3 angle valve job
new SI exhaust valves
port and polished exhaust side
i am asking $500 because the second cylinder is fried and is going to need new rings other than that it is in excellent condition
i also have a JWT ecu programmed for a turbo KA24ET motor with 550cc injectors, Z32 MAFS, 8.5:1CR - i am asking $300
garrett t3/t04e 60 trim .82A/R - $400
custom uppipe for t3 on ka24e - $180
Thanx
Niko