Lack of power after knock sensor install

[Falken180]

Replaced my knock sensor on my ka. Disconnected the battery for 30mins. Hesitates at 2.5k rpm. No power at all. Believe it's in safe mode. Installed Isis knock sensor and sub harness. Erased code also

Any ideas?

[EnnEssEnnKAT]

Did you reset the timing after the install?

[Falken180]

Will try that next. Did that work for you?

[Falken180]

Replaced my tps ground on the harness was broken. checked my timing. Car hesitates alot under full throttle and even half. Any one else? searched around didnt get solid answers

[dorkidori_s13]

Replaced my tps ground on the harness was broken. checked my timing. Car hesitates alot under full throttle and even half. Any one else? searched around didnt get solid answers

clean your MAF sensor with a qtip and MAF cleaner from autozone. dirty MAF will cause all sorts of issues pertaining to acceleration.

also, check voltage on TPS as well. if voltage is off, it can screw up your AF raitos pretty bad.

why didnt you just buy an OE knock sensor? saving a few bucks on vital engine components is a BIG no no! if a nissan OE part can be had as far as sensors go, ALWAYS use OE!

[Thedriftbadger]

Probably got a bad sensor.

[Falken180]

Figured it out was a bad ground wire on the tps and timing was off a tooth. If anyone was wondering