Tein z33 and spl tie rod end combo

[newlovekid]

New thread.....

[newlovekid]

Make an offer. Bump

[adamhanna]

Are these long enough for 25mm extended lca

[newlovekid]

No sorry. You'd have to run pbm inner tie rods for 25mm flca

[kaoliu]

Check out GKTechs tie rod end. similar misalignment range and you get Three different length rods. 0mm, 15mm, and 35mm. Plus the fact that you can run it with stock inners is nice because if you were to curb check anything, your stock inners will absorb the impact rather than everything else. And being able to easily source QA1 ends is icing on the cake - But both spl and gktech uses the same ends. Only gktech is cheapeR - not to be confused with lower quality in this case.

http://www.gktech.com/index.php/high-misalignment-64-degrees-tie-rod-ends-12mm-14mm.html