clifford matrix rsx 3.5 turbo timer installation

[Sil-Abc]

Just wanted to know if anyone knows how to wire up the turbo timer on this alarm. I work at good guys and already have the wiring diagrams but it doesn't display the turbo timer wiring. Does anyone happen to know how to install the turbo timer part and what wires (color wise) are needed to be spliced with the car? Any help would be great. thanks!

[nrg]

I installed this feature on my clifford G4. It should be the same meathod.

any 12 volt bosch 30/40 amp relay will do. make sure it doesn't have a built in 'flasher' motor.

Program Auxiliary B to timed output
Connect the Grey/Blue wire to Pin 85
Pin 86 & Pin 87 to a fused 12 volt source 20 or 30 amp
Pin 30 to Green/Blue wire off the Clifford's Ignition/Starter kill harness

Be sure to turn off the Auto Activation feature if programmed on Aux B. Set Aux B to timed output and you can program up to 4 minutes on Aux B.

Test it by having the vehicle running, press your Aux B channel button and then shut the vehicle down. Remove your key, and then arm your system. Your vehicle should be still running.

If you need to have the Accessory wire running, you will need to use another relay to power the Accessory wire off the WRX's Ignition harness. You could use the same Grey/Blue Aux B wire to trigger this relay as well.

[Sil-Abc]

cool thanks!