Using Z32 MAF /w e-Manage

[lodder]

I am using GReddy e-Manage and am running a z32 MAF. Other than the wiring and telling the emanage in the parameter settings that the z32 Maf is being used, what else do I have to do? I am getting speratic idle and my car doesn't run well from idle to about 3500rpm. I had a code for the Maf, CAS, and ignition signal. We fixed the Maf because we got some grounds mixed up. We cleared the ECU and now it only does the ignition signal. Still does the idle problem and shitty performance to 3500. I now know that it must be somthing to do with the ignition signal. I think that it is problably a ground. If any one running emanage that could give me some advice, please reply.

Other things I am running if you need to know,

T3/T4 57trim
780cc injectors

[Maeda]

ok try this if you need it to run, but don't run like this for long if you have any fancy timing settings.

Just jump into the emanage setup and turn off the ignition map. The car should idle fine now.

[lodder]

I'll try that. I have changed values there.

If that does not work, I'll come back on and see what else we can do!!

Thanks

[candypainted 240sx]

holy cow 780cc injectors what kind of boost are you running? Did it just start doing this when you put the mafs in?