PDA

View Full Version : ISIS Rear Toe and Traction Rod Heim Size and thread pitch?

brianglawson
10-17-2014, 03:14 PM
Hey guys, my s14 came with some ISIS rear toe arms and traction rods on it.

My passenger side rear toe arm has a heim that has started to crap out.

I am looking to just pick up a new heim. I always used RuffStuff Heims on my 3 linked Jeep; they are very stout heims and I figured I would go with those if they had a thread pitch that fit.

Does anyone know the thread pitch for the heims on ISIS links? they are reversed thread I do know.
e1_griego
10-17-2014, 03:50 PM
Probably m16x2.0 but you'd have to double-check that. Midwest Control is where most people by replacement metric rod ends.

BV, SPL and voodoo13 are the only arms that come with 5/8" rod ends, I'm pretty sure and that fact alone makes them more worth it to me.
brianglawson
10-17-2014, 04:43 PM
ahh, wow, I hope they are standard. im going to have to figure this out.. I "think" I may have the stock toe arms too I guess if I get in a pinch.

id rather make my own set than buy an SPL set. I would love to just buy a heim and roll though.
e30gangsta
10-17-2014, 05:22 PM
Its m16x2.0 just bought extra nuts the other day.
e1_griego
10-17-2014, 05:45 PM
Yeah they're definitely not standard, none of the ebay stuff is.
bidiaokais
10-18-2014, 07:50 AM
id rather make my own set than buy an SPL set. I would love to just buy a heim and roll though.http://goo.gl/y0bH7E
brianglawson
10-18-2014, 08:44 AM
Its m16x2.0 just bought extra nuts the other day.

Thanks man. I guess I will order a few Midwest Control heims then.

I imagine a Teflon Race would be best. They have both Narrow and wide housings.. im trying to figure out that difference, then Ill be placing an order

https://www.midwestcontrol.com/part.php?id=2056

These are the ones that I have found in stock that should work
brianglawson
10-18-2014, 08:52 AM
Probably m16x2.0 but you'd have to double-check that. Midwest Control is where most people by replacement metric rod ends.

BV, SPL and voodoo13 are the only arms that come with 5/8" rod ends, I'm pretty sure and that fact alone makes them more worth it to me.

I wonder if stance arms have standard threads...
I ran heims from
www.ruffstuffspecialties.com on my Jeep.. HUGE heims.. LOL They were great, and took tons of abuse.. Ballistic Fabrication makes nice heims too, but again, everything is standard.
brianglawson
10-18-2014, 09:16 AM
They are out of stock on a lot of m16 2.0 options... and obviously, I need Left hand threads... I did find these.. they are chromoly but use Nylon races

https://www.midwestcontrol.com/part.php?id=2921
e1_griego
10-18-2014, 10:11 AM
Stance use three-piece aurora metric ends.
e30gangsta
10-18-2014, 11:38 AM
They are out of stock on a lot of m16 2.0 options... and obviously, I need Left hand threads... I did find these.. they are chromoly but use Nylon races

https://www.midwestcontrol.com/part.php?id=2921

Doubt there is a mitchells supply by you. But if there is you can order through them and they ship.