twitchy
07-14-2004, 12:32 PM
Well i decided to keep my 240 so i had the typical frame munchies welded up yesterday, looks very good! i can use a hoist again!
Im left with no interior on the front driver side as i wait to have 2 holes patched in the floor. One is above the exhaust collector and bakes your feet as you drive, throwing lots of heat inside. Its about the size of my hand. The other is farther back closer to the outside and its about the size of a quarter
Im really happy this rust shit is coming to an end, cause i have an intake, header, muffler / resonator, waiting to be installed as well as electric fans and strut braces on the way but i wanted a rust-free car before i did this. I also installed my Accord Coupe sideskirts-- Pics soon
anyone ever patch up floor holes and or have any advice? Im thinking Ill grind the holes to get rid of the rust and have a piece welded over each one then seal from both sides with rubber undercoating, but is the floor too thin to weld into??
Thanks
Twitchy
Im left with no interior on the front driver side as i wait to have 2 holes patched in the floor. One is above the exhaust collector and bakes your feet as you drive, throwing lots of heat inside. Its about the size of my hand. The other is farther back closer to the outside and its about the size of a quarter
Im really happy this rust shit is coming to an end, cause i have an intake, header, muffler / resonator, waiting to be installed as well as electric fans and strut braces on the way but i wanted a rust-free car before i did this. I also installed my Accord Coupe sideskirts-- Pics soon
anyone ever patch up floor holes and or have any advice? Im thinking Ill grind the holes to get rid of the rust and have a piece welded over each one then seal from both sides with rubber undercoating, but is the floor too thin to weld into??
Thanks
Twitchy