+Waldo+
10-04-2014, 09:08 PM
SR20 for sale
starts and idles fine, and drives can come and see it in the car before it's pulled.
Going to try and sell as a whole but if I get no interest in the first week or so I will part it out. Pretty much turn key swap.
Red top
Bottom end built by engine lab in Tampa
Nissan crank
Recondition Manley rods
CP pistons bored 20 over
Garret 2871 (less than 8k miles)
All steel braided turbo lines
Tial 38mill external waste gate with dump
Nismo 740cc inj
Yamato high flow side feed rail
Mid mount inter cooler pipes
Greddy high capacity oil pan
Greddy catch can
Greddy pullies
Cosworth head gasket
ARP head studs
Freddy intake mani
Slightly bashed HKS bov
New CAS
RAS
Z32 maf
Rom tune by enthalpy
Exedy hyper single (less than 8k miles)
Nissan oil pump (less than 6k miles)
Tomei oil cap
B&M short shifter
Full engine harness
Literally all you will need is a intercooler, driveshaft, radiator, and replace some bearings and have a legit motor. I'm sure I'm missing some stuff too.
Will come with a extra head with full BC springs retainers and all new valve seals and trashed Tomei pro cams. Car made 330 on 19psi
May include one piece drive shaft, brand new koyo, and intercooler but would prefer to keep them.
Asking $2,750
Located in Colorado Springs
Text/call w questions 813-625-zero169
starts and idles fine, and drives can come and see it in the car before it's pulled.
Going to try and sell as a whole but if I get no interest in the first week or so I will part it out. Pretty much turn key swap.
Red top
Bottom end built by engine lab in Tampa
Nissan crank
Recondition Manley rods
CP pistons bored 20 over
Garret 2871 (less than 8k miles)
All steel braided turbo lines
Tial 38mill external waste gate with dump
Nismo 740cc inj
Yamato high flow side feed rail
Mid mount inter cooler pipes
Greddy high capacity oil pan
Greddy catch can
Greddy pullies
Cosworth head gasket
ARP head studs
Freddy intake mani
Slightly bashed HKS bov
New CAS
RAS
Z32 maf
Rom tune by enthalpy
Exedy hyper single (less than 8k miles)
Nissan oil pump (less than 6k miles)
Tomei oil cap
B&M short shifter
Full engine harness
Literally all you will need is a intercooler, driveshaft, radiator, and replace some bearings and have a legit motor. I'm sure I'm missing some stuff too.
Will come with a extra head with full BC springs retainers and all new valve seals and trashed Tomei pro cams. Car made 330 on 19psi
May include one piece drive shaft, brand new koyo, and intercooler but would prefer to keep them.
Asking $2,750
Located in Colorado Springs
Text/call w questions 813-625-zero169