View Full Version : New Vienna Dish 3 piece wheel bolt, torx T40?
dac2828
09-14-2014, 10:49 PM
I've searched quite a bit on the net and I surprisingly cannot find this. I'm trying to separate my Tanabe Speed Star Vienna Dish wheels... they're new and they have these bolts in the attachment. A Torx T40 fits however it's loose. I already stripped one of the nuts on the back with a 10mm closed end wrench. On the bolt there are 12 points and the Torx just has 6 and it seems loose. I'm asking this to prevent from stripping the bolt in addition to the nut. I know to use PB blaster and an impact. Is there a special tool for the bolt head or is a torx T40 it? Thanks in advance
dac2828
09-15-2014, 09:23 AM
Come on, no one knows this. It's a triple square but what size? 6mm? I got too much time into searching for this.
OBEEWON
09-15-2014, 09:43 AM
I can't tell by the picture but I am almost sure that is not a Torx bolt. I have seen sockets with that many points. I forget what they are called. Check Sears for it. As far as size I can't tell you.
Super_OK_S13
09-15-2014, 11:29 AM
Obeewon is right, check sears. I think they are called SPLINE DRIVE BITS... Also check fasenal if you have one in the area.
OBEEWON
09-15-2014, 12:01 PM
Bingo. Spline drive, that's it.
dac2828
09-15-2014, 10:19 PM
I ordered a cornwell set online so that should do it. I searched it as triple square bits... 3x4=12 so I figured that was right. Spline drive may be another word for them IDK. Some sets skip from 8 to 10 mm and some have a 9mm but I'm thinking it's 6mm. Anyway, thanks for the help. I'll update the thread when I get the set in with which size it is.
dac2828
09-15-2014, 10:33 PM
Hmmm... they look like a 90 to me but it's hard to tell. I know... my picture of the bolt is not very good. It's surprising some look 90 and some look 120... these bolts don't appear to be machined very well.
dac2828
09-21-2014, 09:34 PM
8mm triple square is the answer
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.